This guide will walk you through installing your Qube One smart meter. The entire process takes approximately 10 minutes.
Prerequisites
Before you begin, ensure you have:
- Qube One smart meter
- Mounting bracket and screws
- WiFi network credentials
- Qube mobile app installed
- Basic electrical tools
- Voltage tester
Safety Precautions
⚠️ IMPORTANT: Always turn off the main power supply before starting installation. Verify power is off using a voltage tester.
Installation Steps
Step 1: Safety First
Turn off the main power supply at the circuit breaker. Use a voltage tester to verify that power is completely off before proceeding.
Step 2: Mount the Meter
- Mark the mounting location on the wall (1.5-2 meters from ground)
- Drill holes for the mounting bracket
- Secure the bracket using provided screws
- Attach the Qube One meter to the bracket
Step 3: Connect Wires
- Connect the input wire (from main supply) to the input terminal
- Connect the output wire (to load) to the output terminal
- Ensure all connections are tight and secure
- Double-check wire connections against the wiring diagram
Step 4: Connect to WiFi
- Power on the meter by turning on the main supply
- Open the Qube mobile app
- Follow the on-screen instructions to connect the meter to WiFi
- Enter your WiFi network credentials
- Wait for the connection confirmation
Step 5: Verify Installation
- Check the Qube dashboard to verify the meter is online
- Verify that the meter is sending real-time data
- Test the QR code recharge functionality
- Confirm all features are working correctly
Troubleshooting
If you encounter any issues during installation:
- Meter not connecting to WiFi: Check signal strength and credentials
- No data showing: Wait 5-10 minutes for initial sync
- Display not working: Check power supply and connections
Next Steps
After successful installation:
- Set up tariff rates in the dashboard
- Generate QR codes for tenants
- Configure alerts and notifications
- Train tenants on the recharge process
Support
If you need assistance, contact Qube support at support@qube.eco or call our helpline.